Home > General > ProgeSOFT IntelliCAD – Measuring intervals on entities

ProgeSOFT IntelliCAD – Measuring intervals on entities

September 5th, 2005 Leave a comment Go to comments

You can mark specified length increments along a selected entity using either a point entity or a block.

To measure intervals along an entity and mark them using point entities

Advanced experience level
1 Do one of the following:
  • Choose Modify > Measure.
  • On the Modify toolbar, click the Measure tool.
  • Type measure and then press Enter.
2 Select the entity.
3 Specify the segment length, and then press Enter.

Image_1_12

To measure intervals along an entity and mark them using blocks

Advanced experience level
1 Do one of the following:
  • Choose Modify > Measure.
  • On the Modify toolbar, click the Measure tool.
  • Type measure and then press Enter.
2 Select the entity.
3 In the prompt box, choose Insert Blocks.
4 Type the name of the block you want to insert as the
   marker.
5 In the prompt box, choose either Yes-Align Blocks to
   rotate each insertion of the block so that its vertical
   alignment is always perpendicular to the entity or No-Do
   Not Align to insert each copy of the block with a zero
   rotation angle.
6 Specify the segment length, and then press Enter.



Originally posted by ProgeSOFT from Learning IntelliCAD

Categories: General Tags:
  1. No comments yet.
  1. No trackbacks yet.
You must be logged in to post a comment.